DRIVING

DRIVING POSITION

Seats, Rear-view Mirrors, Seat Belts

FRONT BENCH SEAT (Fig. 8) Fore-and-aft adjustment: Raise the handle situated to the driver's right hand side (1) and slide the bench seat towards the front or rear. (Sliding travel: 7 notches) To remove the seat: Withdraw the securing pin situated on the floor to the right of the central seat frame (central part), raise the handle (1), then slide the seat backwards out of its runners. Make sure the securing pin is re-positioned when replacing the seat.

Fig. 8 Front bench adjustment 1 - Handle

SEPARATE FRONT SEATS  (Fig. 9) (on certain models) Fore-and-aft adjustment: Raise the handle (1) which is situated to the driver's right hand side or the passenger's left hand side and slide the seat towards the front or rear. (Sliding travel: 7 notches) To remove the seat: Withdraw the securing pin situated on the floor, next to the RH seat frame. Raise the handle (1) then slide the seat backwards out of the runners. Make sure the securing pin is re-positioned when replacing the seat.

Fig. 9 Separate front seats adjustment 1 - Handle

REAR BENCH SEAT  (Fig. 10) To remove the seat: Release the rear peg (1) by turning the lever towards the centre line of the vehicle. Tilt the seat forward to disengage its lower securing pegs from the floor. Make sure the securing pegs are re-positioned when replacing the seat.

Fig. 10 Removal of rear bench seat 1 - Release lever

REAR-VIEW MIRROR These vehicles are equipped with an interior rear-view mirror and an exterior one on the driver's side. On "Commercial" versions (French market vehicles) an additional exterior rear-view mirror has been fitted on the passenger's side of the car.

SEAT BELTS (Fig. 11) (French market) To fasten: Engage the end of the levered buckle into the flexible buckle of the same colour. To unfasten: Release the lever (1). Adjustment: The belt buckle must be level with the hip, at the side, and the strap should cross the chest. Alter the length of the short part (towards the centre of the vehicle), by sliding the strap into the adjustment buckle, the belt should be adjusted so that it is not too tight on the body. These belts are not designed for children under siz years of age, and any one belt must be used by one person only. The belts must not be twisted whilst in use, nor must they be rubbed against edges, since this may result in wear or breakage. When a seat belt is not in use, hook the lever end, inserting it into the buckle situated under the upper anchorage point - to release it, move the opening lever. If the belts have undergone any strain due to impact, replace them and have the anchorages checked. For markets outside France, consult your Citroën dealer who will advise you on the legal requirements and fittings.

Fig. 11 Seat belt 1 - unfastening 2 - Adjusting buckle

DRIVING POSITION Adjust the fore-and-aft position of the bench-seat or of the front driver's seat to suit the controls. Adjust the rear-view mirrors to suit the driving position adopted. Then fasten the seat belt and adjust its length as necessary.

[Contents] [Notices] [Important Points] [Driving] [Maintenance] [Minor Repairs] [Miscellaneous Information]